Skip to content
All apps

Motor im Schnitt — Honda GX160 (3D)

About this app

Ein echter Einzylinder-Viertakter (68 × 45 mm, 163 cm³, OHV) maßstäblich als Schnitt- und Explosionsmodell: Kurbelwinkel 0–720° drehen, Kolben, Pleuel, Kurbelwelle, Nockenwelle mit 2:1-Zahnrädern, Stoßstangen, Kipphebel und Ventile arbeiten sehen; Gas färbt sich je Takt, Zündung vor OT, Ventilüberschneidung sichtbar, p-V-Diagramm läuft mit.

The four-stroke cycle

A four-stroke engine needs two crankshaft revolutions, 720°, for one working cycle. On the intake stroke the descending piston draws in fresh mixture; on the compression stroke it squeezes it with both valves closed. Shortly before top dead centre (TDC) the spark plug fires, and combustion pressure drives the piston down on the power stroke. On the exhaust stroke the piston pushes the burnt gas out through the exhaust valve. Only the power stroke delivers work; the flywheel carries the engine through the other three. The camshaft turns at half crank speed via timing gears (2 : 1), so each valve opens once per cycle.

What the app shows

A Honda GX160, an air-cooled single cylinder with 68 mm bore, 45 mm stroke and 163 cm³ displacement, as a cutaway and exploded model. The valves sit in the cylinder head and are worked by camshaft, tappets, pushrods and rockers (OHV). A slider turns the crank from 0 to 720°, and the gas in the cylinder changes colour with each stroke. Charts show intake and exhaust valve lift against crank angle and a qualitative p-V diagram. Every part, from piston to carburettor, can be clicked for an explanation.

What to watch for

Turn the crank slowly through the full 720° and count: the piston goes up and down twice, but the plug fires only once. Stop at the change from exhaust to intake. Both valves are briefly open at the same time there, which is valve overlap, so valves do not open and close exactly at the dead centres. Switch on the exploded view to follow the chain from cam to pushrod and rocker to valve. The valve timing in the app uses typical values, not GX160 data.

Frequently asked questions

How does a four-stroke engine work?
A four-stroke engine runs through intake, compression, power and exhaust. The crankshaft turns twice, 720°, during one cycle. Only on the power stroke does combustion pressure push the piston; the flywheel carries the engine through the other strokes.
What is valve overlap?
Valve overlap is the short period around top dead centre between the exhaust and intake strokes when both valves are open at once. The outflowing exhaust helps draw in fresh charge and scavenge the cylinder. How long the overlap lasts is set by the shape of the cams.
What does OHV mean on an engine?
OHV stands for overhead valves in the cylinder head. The camshaft sits low in the engine block and opens the valves through tappets, pushrods and rocker arms. In an OHC engine the camshaft itself sits in the cylinder head.
Why does the camshaft turn at half the crankshaft speed?
Each valve should open only once per working cycle, and one cycle takes two crank revolutions. The timing gears therefore reduce the speed 2 : 1. In the app you can see both gears turning in the cutaway.

Subject: Automotive engineering

More from Automotive engineering

A VisuApp by heyprof: interactive, free in your browser, no sign-up. What is a VisuApp? · All apps