Skip to content
All apps

Diode & rectifier

About this app

Diode characteristic plus half-wave and bridge rectifier: an input sine becomes u_out across the load, smoothing capacitor switchable (ripple visible) — characteristic and time course side by side.

Diodes and rectification

A diode conducts current almost only in the forward direction. Its characteristic follows the Shockley equation I = I_S·(e^(U/U_T) − 1): in silicon, significant current flows only above about 0.7 V, and in reverse practically none. A half-wave rectifier with one diode passes only the positive half-cycles. A bridge rectifier with four diodes also flips the negative half-cycles up, at the cost of two forward voltage drops. A smoothing capacitor charges to the peaks and discharges through the load in between. The remaining ripple is roughly Δu ≈ I_L/(f_r·C).

What the app shows

On the left is the diode characteristic I(U); on the right the waveforms of the input u_in and output u_out. A toggle chooses half-wave or bridge, and the model used (u_out = max(u_in − U_F, 0) or max(|u_in| − 2·U_F, 0)) is displayed. An optional smoothing capacitor makes the ripple visible. A panel shows peak, mean and ripple of the output voltage.

Things to try

Switch between half-wave and bridge and compare the output mean. Add the capacitor and increase its value: the ripple shrinks. Lower the load resistance and the capacitor discharges faster, so the ripple grows again. With the same capacitance the bridge output is smoother, because its ripple frequency is twice as high.

Frequently asked questions

How does a bridge rectifier work?
A bridge rectifier uses four diodes, two of which conduct during each half-cycle. The current through the load therefore always flows in the same direction, and the negative half-cycles are used too. The output is two diode drops lower than the input peak.
What is the difference between half-wave and full-wave rectification?
A half-wave rectifier uses only one half-cycle and blocks the other. Full-wave rectification, for example with a bridge, uses both. It gives a higher mean output and twice the ripple frequency, which makes smoothing easier.
How do you calculate ripple voltage after a smoothing capacitor?
A common approximation is Δu ≈ I_L/(f_r·C), with load current I_L, ripple frequency f_r and capacitance C. For a half-wave rectifier f_r equals the supply frequency; for a bridge it is twice that. A larger capacitor or smaller load current reduces the ripple.
What can I adjust in the rectifier app?
You choose half-wave or bridge rectification, set amplitude and frequency of the input and add a smoothing capacitor with adjustable capacitance. The load resistance can be changed as well. The diode curve and the waveforms appear side by side.

Subject: Electrical engineering fundamentals

More from Electrical engineering fundamentals

A VisuApp by heyprof: interactive, free in your browser, no sign-up. What is a VisuApp? · All apps