Skip to content
All apps

Series and parallel resistors

About this app

Pill-toggle series vs. parallel with up to three resistors: equivalent resistance (R = ΣR or 1/R = Σ1/R), current/voltage division live in the circuit with flowing charge carriers and a split table.

Series and parallel

In a series circuit, resistors sit one after another. The same current flows through all of them, the source voltage divides in proportion to the resistances, and the total resistance is the sum: R_tot = R₁ + R₂ + R₃. In a parallel circuit, all resistors connect to the same two nodes and therefore share the same voltage. The current splits, and the reciprocals add: 1/R_tot = 1/R₁ + 1/R₂ + 1/R₃. The total is then smaller than the smallest single resistor.

What the app shows

One toggle switches between series and parallel, another chooses one, two or three resistors. Charge carriers move through the circuit diagram; in parallel mode each branch shows a density that matches its own current. The results panel shows the equivalent resistance with the formula written out, the total current and a table of voltage shares (series) or branch currents (parallel).

Things to try

Choose two resistors in series and make one much larger: it takes the larger share of the voltage. Then switch to parallel and notice that the smallest resistor carries the largest branch current. Add a third resistor and compare how the total resistance changes in each arrangement: it rises in series and falls in parallel.

Frequently asked questions

How do you calculate resistors in series?
Resistors in series simply add up: R_tot = R₁ + R₂ + … So 100 Ω and 220 Ω in series give 320 Ω. The current is the same at every point of the circuit.
How do you calculate resistors in parallel?
For resistors in parallel the reciprocals add: 1/R_tot = 1/R₁ + 1/R₂ + … For two resistors there is the shortcut R_tot = R₁·R₂/(R₁ + R₂). The result is always smaller than the smallest individual resistor.
Why does the smallest resistor carry the most current in parallel?
Every branch of a parallel circuit has the same voltage U across it. By Ohm’s law the branch current is I = U/R, so it is larger when the resistance is smaller. The branch currents are inversely proportional to the resistances.
What can I adjust in the series and parallel app?
You choose series or parallel, the number of resistors (one to three), their values between 10 and 1000 Ω and the source voltage up to 24 V. Equivalent resistance, total current and how it divides among the resistors update immediately.

Subject: Electrical engineering fundamentals

More from Electrical engineering fundamentals

A VisuApp by heyprof: interactive, free in your browser, no sign-up. What is a VisuApp? · All apps