Skip to content
All apps

Phantom traffic jam — jam waves out of nowhere (3D)

About this app

22 cars on a ring road: above a critical density a brief braking turns into a jam wave that travels backwards. Space-time and fundamental diagrams show why tailgating lowers the flow and why a few ACC cars smooth out the waves.

Jams without a cause

A phantom jam forms without an accident, roadworks or a bottleneck. Above a critical density, smooth traffic is unstable: one car brakes briefly, the next brakes a little later and a little harder, the one after that harder still. The disturbance grows into a stop-and-go wave that travels against the direction of traffic, typically at 15 to 20 km/h. Cars enter the wave at the back and leave it at the front. In the experiment by Sugiyama et al. (2008), 22 cars on a 230 m circle soon produced such a jam.

Inside the simulation

The 3D ring road recreates that experiment: 8 to 36 cars drive in a circle, each following the Intelligent Driver Model with a desired speed of 50 km/h. A space-time diagram draws every car as a line, and the jam wave shows up as a band running downwards. The fundamental diagram plots flow against density, shades the unstable range and marks the measured state, which drops below the curve inside a jam. Average speed, slowest car and wave speed are shown as well.

Experiments to run

Pick the scenarios “Sugiyama”, “Free flow”, “One braker” or “ACC helps”. Tap a car to make it brake briefly and see whether the disturbance dies out or grows. Shorten the time gap T: tighter following pushes traffic into the unstable range and measured flow falls. The “ACC cars” slider adds up to four vehicles with a smoothing controller inspired by Stern et al. (2018). The camera switches between overview, low view and ride-along.

Frequently asked questions

How does a traffic jam form out of nowhere?
At high density, drivers react with a delay and slightly too strongly to the car ahead braking. A small disturbance therefore grows from car to car until some vehicles come to a stop. No external cause is needed, only a density above the stability limit.
Why do traffic waves move backwards?
At the front of the wave cars accelerate away, at the back new cars arrive and brake. The zone of slow or stopped cars therefore shifts against the direction of travel, on motorways typically at 15 to 20 km/h. The wave moves differently from the individual vehicles.
What does the fundamental diagram of traffic flow show?
It plots traffic flow (vehicles per hour) against density (vehicles per kilometre). At low density flow rises with density; beyond a critical density it falls again. In congested traffic the measured flow lies below what smooth traffic at the same density would achieve.
Which model does the app use?
Each car follows the Intelligent Driver Model with a desired speed of 50 km/h, a minimum gap of 2 m and an adjustable time gap, and “dawdling” adds a random acceleration noise. The simulation has one lane, no lane changes and no separate reaction time. The stability limit in the fundamental diagram comes from a linear analysis of the model.

Subject: Logistics & Supply Chain

More from Logistics & Supply Chain

A VisuApp by heyprof: interactive, free in your browser, no sign-up. What is a VisuApp? · All apps