Skip to content
All apps

Phasors & impedance

About this app

Complex AC analysis of the RLC series circuit: Z = R + j(ωL − 1/ωC); the voltage phasors U_R, U_L, U_C add up to the total voltage, phase angle φ and |Z| live, alongside u(t) and i(t) with their phase shift.

Complex AC analysis

In a series RLC circuit the same current flows through every component. The resistor voltage U_R is in phase with it, the inductor voltage U_L leads by 90° and the capacitor voltage U_C lags by 90°. Treating these as complex phasors, the impedance is Z = R + j(ωL − 1/(ωC)). Its magnitude is |Z| = √(R² + X²) with reactance X = X_L − X_C, and the phase angle follows from tan φ = X/R. When X_L = X_C the circuit is at resonance and behaves purely resistively.

What the app shows

On the left is the phasor diagram in the complex plane: the phasors U_R, U_L and U_C add as vectors to the total voltage U. On the right you see u(t) and i(t) with the time shift φ. A values panel shows R, X_L, X_C, X, |Z|, φ, the magnitudes of the component voltages and whether the circuit is inductive, capacitive or purely resistive.

Things to try

Adjust R (1 to 200 Ω), L (0 to 300 mH), C (5 to 500 µF) and the frequency (10 to 400 Hz). Raise the frequency: X_L grows, X_C shrinks, and the circuit changes from capacitive to inductive. The “Tune to resonance” button sets the frequency so that U_L and U_C cancel. Notice that U_L and U_C can each be larger than the total voltage.

Frequently asked questions

What is impedance?
Impedance Z is the complex AC resistance of a component or circuit. Its real part is the resistance R, its imaginary part the reactance X. Its magnitude |Z| links the RMS values of voltage and current: U = |Z|·I.
How do you calculate the impedance of a series RLC circuit?
Add the complex impedances: Z = R + jωL + 1/(jωC) = R + j(ωL − 1/(ωC)). The magnitude is |Z| = √(R² + (ωL − 1/(ωC))²). The phase angle follows from tan φ = (ωL − 1/(ωC))/R.
Why does the voltage across an inductor lead the current?
For an inductor u = L·di/dt, so the voltage is proportional to the rate of change of current. With a sinusoidal current, that rate is largest where the current crosses zero. The voltage therefore peaks a quarter period earlier and leads by 90°. For a capacitor it is the other way round.
What can I adjust in the phasor diagram app?
You set R, L, C and frequency and see the phasors U_R, U_L, U_C and U along with u(t) and i(t). A button tunes the circuit to resonance. The panel shows reactances, |Z|, φ and whether the circuit is inductive or capacitive.

Subject: Electrical engineering fundamentals

More from Electrical engineering fundamentals

A VisuApp by heyprof: interactive, free in your browser, no sign-up. What is a VisuApp? · All apps