Skip to content
All apps

Voltage divider

About this app

Unloaded and loaded voltage divider: U_out = U·R2/(R1+R2), draggable wiper, load resistor switchable (shows the drop under load) — with a plot of U_out over wiper position.

The idea

A voltage divider is two resistors R1 and R2 in series. The output is taken across R2 and, without load, equals U_out = U·R2/(R1 + R2). It depends only on the ratio of the resistances, much like the wiper of a potentiometer. If a load resistor R_L is connected across R2, the parallel combination R2‖R_L replaces the lower resistor. It is smaller than R2, so U_out drops. The drop stays small when R_L is much larger than R2.

What the app shows

The circuit diagram shows the divider with a wiper you can drag directly. A load resistor R_L can be switched in. A plot shows U_out/U against the divider ratio k = R2/(R1 + R2): the unloaded curve is a straight line, the loaded one runs below it, and a marker shows the current setting. A values panel lists the ratio, U_out with and without load, the drop and the load current.

Things to try

Set the input voltage up to 24 V and R1, R2 between 0.1 and 10 kΩ. Switch on the load and reduce R_L step by step: the loaded curve sags more and more, especially when R2 is large. Then compare a divider made of small resistors with one made of large resistors under the same load. The low-resistance divider holds its output better but draws more current.

Frequently asked questions

How do you calculate the output of a voltage divider?
For an unloaded divider, U_out = U·R2/(R1 + R2), with U_out measured across R2. With 12 V and two equal resistors you get 6 V. The result depends only on the resistance ratio.
Why does a voltage divider’s output drop under load?
The load resistor sits in parallel with R2. The combination R2‖R_L is smaller than R2, so less voltage appears across the lower part. In the formula you replace R2 by R2·R_L/(R2 + R_L).
When can a voltage divider be treated as unloaded?
A common rule of thumb is that the load should be much larger than R2, often about ten times larger. The output then stays close to the ideal value. For a stable supply voltage, a voltage regulator is usually used instead of a plain divider.
What does the voltage divider app show?
It shows a divider with a draggable wiper, an optional load resistor and a curve comparing the loaded and unloaded cases. Input voltage, R1, R2 and R_L are set with sliders, and U_out, the drop and the load current are calculated.

Subject: Electrical engineering fundamentals

More from Electrical engineering fundamentals

A VisuApp by heyprof: interactive, free in your browser, no sign-up. What is a VisuApp? · All apps