Power contactor (3D)
About this app
A cutaway model of a contactor switches a three-phase motor: pushbuttons S1/S0, coil, armature and contact bridges live — latching via K1 13/14 can be switched on/off (jog mode vs. restart protection), circuit diagram with live-colored current paths.
With explain mode: an AI tutor walks you through the app, points out what matters in the scene and answers your questions.
How a contactor works
A contactor is an electromagnetically operated switch. A small control current through the coil (terminals A1/A2) creates a magnetic field in the iron core that pulls in the armature. The armature moves the contact bridges and closes the three main contacts 1–6, which carry the large motor current. This lets a pushbutton in the control circuit switch a three-phase motor safely. When the coil current stops, return springs push the armature back and the contacts open. Opening under load produces a switching arc.
Latching and restart protection
Auxiliary contact 13/14 closes together with the main contacts and is wired in parallel with the start button S1. Once it closes, the coil keeps itself energised and S1 can be released: this is the latching or self-holding circuit. If S0 is pressed or the supply fails, the contactor drops out and stays off until someone presses S1 again. This protection against automatic restart is the safety core of many motor controls. Without latching, the motor runs only while S1 is held down (jog mode).
Things to try
Press and hold S1, then release it, once with and once without latching. The cutaway shows coil, armature, contact bridges and motor, optionally with housing and visible magnetic flux, and a slow-motion control stretches the switching process. The schematic panel highlights control current and load current live, and the state panel lists coil, armature, main and auxiliary contacts and motor speed. You can rotate and zoom the scene freely. An explain mode lets an AI tutor guide you through the app.
Frequently asked questions
- What is the difference between a contactor and a relay?
- Both are electromagnetically operated switches. A contactor is designed to switch large load currents such as motors and usually has three main contacts plus auxiliary contacts. A relay typically switches smaller currents in control and signal circuits.
- What is a latching (self-holding) contactor circuit?
- In a latching circuit, a normally open contact of the contactor, usually auxiliary contact 13/14, is wired in parallel with the start button. Once the contactor pulls in, this contact keeps the coil circuit closed after the button is released. A normally closed stop button in series, such as S0, breaks the circuit and switches off.
- What do the terminal markings A1/A2, 1–6 and 13/14 on a contactor mean?
- A1 and A2 are the coil terminals. 1 to 6 identify the three main contacts, with odd numbers on the supply side and even numbers on the load side. 13/14 is an auxiliary normally open contact: the 1 is the sequence number and 3/4 marks a make contact.
- Can I try jog mode in the app?
- Yes. If you switch off latching via K1 13/14, the motor runs only while you hold S1. With latching enabled it keeps running after you release S1 until you press S0.
Subject: Electrical & Control Engineering
More from Electrical & Control Engineering
- Three-phase asynchronous motor (3D)
- A week of power
- Cable decoder
- Electric arc & arc-suppression elements
- Motor protection lab
- Diagram-types explorer
- Circuit-symbol trainer
- Contactor circuit simulator
A VisuApp by heyprof: interactive, free in your browser, no sign-up. What is a VisuApp? · All apps